A machine part subjected to an axial compressive force is called a strut. A strut may be horizontal, inclined, or even vertical. But a vertical strut is known as a column, pillar, or stanchion. The machine members that must be investigated for column action are piston rods, valve push rods, connecting rods, screw jack, side links of toggle jack, etc. In […]
Archives for May 2023
What is Rankine’s Formula for Columns?
Usually, it is a common phenomenon observed in long columns failure due to buckling load and the short columns usually fail due to crushing load. The Rankine-Gordon formula assumes a combined failure mode which is combined buckling and crushing loads in columns. This common mode is known as the Rankine formula for columns. Hence, we […]
What is Euler’s Column Theory?
A machine part subjected to a vertical axial compressive force is called a column. it is also known as a pillar or stanchion. We see this vertical axial compressive force such as piston rods, valve push rods, connecting rods, screw jack, side links of toggle jack, etc. The first rational attempt, to study the stability of long columns, […]
What is Column? | Failure of a Column
A machine part subjected to an axial compressive force is called a strut. A strut may be horizontal, inclined, or even vertical. But a vertical strut is known as a column, pillar, or stanchion. The machine members that must be investigated for column action are piston rods, valve push rods, connecting rods, screw jack, side links of toggle jack, etc. Let […]
Procedure for Designing Rocker’s Arm for Exhaust Valve
A rocker’s arm is a valvetrain component that typically transfers the motion of a push rod to the corresponding intake/exhaust valve. The rocker’s arm is used to actuate the inlet and exhaust valve motion as directed by the cam and follower. Let us see if we can design Rocker’s Arm for Exhaust Valve for a petrol […]
Find stiffness of the spring in Hartnell Governor
Hartnell Governor is basically a Centrifugal governor with a spring-loaded weight instead of dead weight on the sleeve to increase the speed of the balls required to lift the sleeve on the spindle. The Bell crank Lever holds two dead-weight balls for a Hartnell governor in order to regulate the fuel flow for the engines […]
How to Design a Bell Crank Lever?
The Bell crank lever consists of two arms at right angles. Such types of levers are used in railway signaling, governors of Hartnell type, the drive for the air pump of condensers, etc. Let us design a simple Bell Crank Lever for one of these applications. In the previous articles, we have discussed different Mechanical […]
How to Design a Lever Safety Valve?
A Mechanical Lever is a rigid rod or bar capable of turning about a fixed point called a fulcrum. It is used as a machine to lift a load by the application of a small effort. Lever Safety Valve is used to maintain a constant safe pressure inside the boiler. When the pressure inside the boiler increases the […]
How to design Cranked lever? | Crankshaft
A cranked lever is a hand lever commonly used for operating hoisting winches. Usually, a Mechanical Lever is a rigid rod or bar capable of turning about a fixed point called a fulcrum. It is used as a machine to lift a load by the application of a small effort. Let us discuss more on how we can […]